Auto trans to Hemi ?

I am wanting to put a 426 type Hemi motor in a 'Cuda I have. The motor I have has a Bryant crank in it and has no register for the nose of the torque converter.Does anyone make an adapter that would fit on the O.D. of the flange of the crank with a register for the converter on it? How does a Lencodrive setup register the torque converter when a competition crank like this is used?

Thanks-Dale

 

dale call craig at coan converters at 765-456-3957. he has what you need, i run it for 3 years and no problems.

 

problem

Ditto Coan can cure any problem. Don

 

TCI makes one..Dave

 

buy a meziere billet flexplate. no adapters, it's all one piece and is extremely stout. Make sure and use some antisieze on the converter.

 

ditto on the meziere - they also will re-sfi if it is not hurt - ask others if they will do that without charging you too much $$$. andy b

 

Got mine and the flexplate from JW.

 

Reason

Forgot to mention why I got the Meziere in the first place, I've slung the ring gear off both a CSR and a JW M
Meziere is all one piece, trick as hell, too bad you can't see it on the car

 

My JW "the wheel" flexplate failed on the warmup stand, before ever making a pass !! Quick call to Johnny Winters and I got told "NO WARRANTY" would never buy his crap again

 

ditto

same goes for their shafts,didn't make a full burnout on a 4.30 1/8 car.

 

I got an older reactor alum flexplate, with a steel ring gear,hope it stays on!Anyone use them?

 

Yea I use a new one, only have 15, 8500 rpm passes on it though