Blower to Manifold O Ring

Discussion in 'PSI Superchargers Tech Questions' started by nitrorelapse, Apr 3, 2009.

  1. nitrorelapse

    nitrorelapse Member

    Joined:
    Nov 27, 2008
    Messages:
    203
    Likes Received:
    1
    My PSI blower has an O ring and my BAE manifold has an O ring. I am guessing, key word guessing, I need to take the O ring out of the manifold leave the one in the blower and put a manifold gasket between them. I figure someone has ran into this before.
     
    #1
    nitrorelapse, Apr 3, 2009
  2. KEITH CLARK

    KEITH CLARK Member

    Joined:
    Oct 13, 2004
    Messages:
    300
    Likes Received:
    1
    If you have to run a blower restraint the plate would solve you problem.
    Just put a 1/4" aluminum plat between the blower and manifold
     
    #2
    KEITH CLARK, Apr 3, 2009
  3. Bob69

    Bob69 Member

    Joined:
    Jul 31, 2007
    Messages:
    151
    Likes Received:
    0
    PSI screw or roots. Screw needs a adaptor (manifold plate).
    cheers
     
    #3
    Bob69, Apr 3, 2009
  4. Doug

    Doug Member

    Joined:
    Jan 26, 2004
    Messages:
    154
    Likes Received:
    0
    Do you have a restraining plate in between the blower and manifold?
     
    #4
    Doug, Apr 3, 2009
  5. nitrorelapse

    nitrorelapse Member

    Joined:
    Nov 27, 2008
    Messages:
    203
    Likes Received:
    1
    It is a roots. The only restraining plate I have is between the injector and the blower.
     
    #5
    nitrorelapse, Apr 3, 2009
  6. MKR-588

    MKR-588 Member

    Joined:
    May 2, 2008
    Messages:
    148
    Likes Received:
    0
    X2. Would be the best way that I can see with no problems. Make sure you have enough belt.
     
    #6
    MKR-588, Apr 4, 2009

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM