HEMI FUEL HEADS

HOW DO I DETERMINE WHICH FUEL HEAD I HAVE? THERE ARE NO MARKINGS ON THE END LIKE: BAE, AJPE,ETC. JUST CURIOUS.

THANKS.

SENT FROM MY TRIGGER FINGER!!!

 

Chamber cc, number of intake bolts, number of exhaust bolts, intake and exhaust size is only a start. Many variations. Find an old timer fuel racer close by.

 

Old timers are basically non existant around here in East Texas. I was just curious if there was a quick way to ID them since they don't have the letters on the ends of the heads. I have been told that they are BAE heads. Sounds good to me. Either way they are the ones that I am going to use. LOL.

 

Try darkside.ca, a lot of information there...

 

Post up some pics of the above mentioned items here and maybe someone will chime in. You can click on the upload fil tab and select the picture(s) you want and upload them into your post.

 

Will have to get some pics of the outside of the heads. Outside of head is all machined, like a billet head. 10 bolt intake and 10 bolt exhaust. Was told they are Brad 3 fuel heads. Was also told they are Vinney's. No idea. Just curious.

 

Not sure what they are, but they're "not" Veney's...

 

Hi all!
i'm experiencing the same problem as Mr Jordan:
i don't know what those are!
they are on an engine i bought some 15 years ago,they have twin plugs,5 intake stud pattern,10 stud exhaust pattern,2.375 intake valves and 2.00 exhaust.no numbers cast or stamped.

any kind of help appreciated!

 

This is a pic before installation. Hard to see in car with motor plates and stuff. Maybe this will help. If not maybe I can do something else. Thanks.

 

intake ports are 2.1/8 long by 2.1/4 high
they take KB valve covers

 

thanks a lot!!

 

This is the best I can get. Everything is in the way for a good pic. The exhaust ports are rectangle. 2" tall by 2.5" wide. Got gaskets from RBS. says they fit BAE,AJPE, and Dart.

 

I will look the next time I have zoomies off. And see what I find. Thanks

 

hi all!
having just read the "cost of running" thread,i have questions about the valvetrain in my old heads:what manufacturer do i go to to buy rocker arms for my stuff?
how do i determine the right ratio?
not all my exhaust rockers are roller(6/8 are)and none of the intake rockers are...this setup is as bought.

i take the opportunity to wish you all the best for 2019!!

 

My fuel head rockers are all from Stage V - rollers everywhere and look to be decent pieces.

 

thanks a lot for info!!

 

If you havent figured out your heads, You can look up these header flange plates from good vibes and get close. Each plate page has a printable dimension drawing that is handy.

http://www.goodvibesracing.com/custom_headers.htm#HemiFlanges