Big NEW list of parts for sale! Engine, Ignition, Driveline & More!

I just got some more parts in, so here's the new list. If you are looking for it, drop me a line!

Engine Hardware -

-PSI Top/Bottom pulley combo for 92 over. 8 mm. 71 bottom/37 top - $250 for the combo
-RCD TDC Pointer/Crank trigger mount. Old style drop in pointer - $150
-Gorr "All in one" 20 port distribution block. Run your blower nozzles and port nozzles (up to 16) with 3 different check pressures. Trick billet deal - $400
-7 used Darton sleeves. Just have a bunch of runs on them. Would make good 'emergency' spares. $150
-Manton 3/8 push rods - 11 15/16" and 11 1/2" . Complete set with spares (6 intake/8 ex)- $150 OBO
-1 ea new upper Clevite thrust (V style) - $15
-4 ea new upper/lower Clevite main bearings (M style) - $40 for all
-TAK Titanium blower restraint mounts - $350 (all 5)

MSD/Ignition/Electrical

-MSD Red coil - $150

Clutch/Trans/Driveline -

- MW 40 spline live axle - $250
- 4 ea NEW Crower 10" small stand floaters (small ID) - $200 for all 4
- AFT 10.5 6 finger Centrifugal Lock up clutch. This is the TAD/TAFC/Pro Mod legal clutch that has 3 standard levers and 3 lock up levers that are spring loaded to make them come in later. It's not the outlaw style multi-stage lock up clutch that uses a solenoid to control the throw out bearing. This unit has low runs and will be recertified for buyer. This is a pedal style clutch, not a glide $1500 OBO
- B&J input shaft - $100
- B&J intermediate shaft (short for dragster) and double female coupler (shaft to shaft) - $100
- B&J Long male coupler - $75
- B&J Short male coupler - $50

Chassis/Accessory parts -


-Small CO2 Bottle - $45
-New set of straps for DJ/Diest carbon bucket (leave the straps on your car and send these for recert) - make offer
-BG Weather Station(partial) - calculator needs battery, altimeter is there but missing weather station. Pelican case included. - make offer
-3 ea Normally Open Whitey valves - $100 for all 3
-NEW Taylor Engine Diaper for FC/Pro Mod - $750

Tools/Support -

- On-head flip style spring changing tool for Fathead style head (does intake and exhaust) - $125

Pics available on request.

I prefer a text or email.

Will Hanna
979.415.4959
will.hanna@insidetopalcohol.com

 

bump

front row!

 

bump

to the top!

 

sold

Sorry rotors were sold last week.

 

Sorry don't have one

Sorry I don't have any electric fuel management at the moment.

 

replies

Sorry for the missed replies. The valve spring tool will not work on a veney and I had a sale pending on it when you asked.

I will get you the measurements on the floaters tomorrow morning.

 

front row

bump to the top

 

front row

still some good deals on parts here

 

clutch

The clutch is a pedal style clutch. It just has 3 lock up fingers that are centrifugally controlled, not throwout bearing controlled, so it is NHRA legal.

 

front row

bump to top