Pro Extreme door car

Discussion in 'PSI Superchargers Tech Questions' started by KZ5 Blown SBC, Sep 9, 2014.

  1. KZ5 Blown SBC

    KZ5 Blown SBC Member

    Joined:
    Aug 2, 2013
    Messages:
    96
    Likes Received:
    7
    Wondering if anyone can share any advice about crank CL an engine angle in pro extreme door car it's going too have a brad 8 with a screw on it with a 3 speed rossler trans.Thanks Robert
     
    #1
    KZ5 Blown SBC, Sep 9, 2014
  2. turbo69camaro

    turbo69camaro Member

    Joined:
    Nov 26, 2007
    Messages:
    250
    Likes Received:
    10
    I rebuilt a screw blown pro mod over the winter. Used 9 1/4 crank C/L in front motor angled up with C/L intersecting pinion C/L
     
    #2
    turbo69camaro, Sep 9, 2014
  3. KZ5 Blown SBC

    KZ5 Blown SBC Member

    Joined:
    Aug 2, 2013
    Messages:
    96
    Likes Received:
    7
    Is that crank CL from the bottom of the chassis.
     
    #3
    KZ5 Blown SBC, Sep 9, 2014
  4. turbo69camaro

    turbo69camaro Member

    Joined:
    Nov 26, 2007
    Messages:
    250
    Likes Received:
    10
    ground !!!
     
    #4
    turbo69camaro, Sep 10, 2014
  5. KZ5 Blown SBC

    KZ5 Blown SBC Member

    Joined:
    Aug 2, 2013
    Messages:
    96
    Likes Received:
    7
    Thanks for the info once again
     
    #5
    KZ5 Blown SBC, Sep 10, 2014
  6. promodracer

    promodracer Member

    Joined:
    Jan 8, 2008
    Messages:
    359
    Likes Received:
    2
    crank centerline

    10" to 10 1/2' centerline to ground is best for blown cars.
     
    #6
    promodracer, Sep 14, 2014

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM