enderle nozzel leak down %

guys,

can anyone leak down some enderle nozzels for me?
im chasing a figure of around 47 %
my enderle nozzel selection only go to #45, which is around 35 % leak down

im trying to get a enderle nozzel , the same size as a hilborn #47 screened nozzel

also, my leakdown tester, reads 80 @ 80.

thanks

 

Sounds like you need to get your Hilborn hooked up to your leakdown and see what it leaks. Than hookup a Enderle thats almost up to the Hilborn and finish it off by opening up the hole until it matches your Hilborn percent leakdown.

 

yes, i have the #47 hilborn now...that equals 47%
the largest enderle i have is #45 enderle....

thats why i was asking , before i go buy a hand full of different nozzels to find what equals 47 %......


thanks

 

Give me the weekend , and i will get you some numbers.

Clayto.

 

They vary too much to get you closer than what you probably already are. Flow the #45 Enderle and drill it out to get 47%

 

ta mate, already rung ken too...no answer there...

-----------

Sodak,
thanks mate, trying to get a enderle size number

 

Hey Ash,

Chat to Spud he will have the answer, I am sure I have seen a conversion table on the old interweb as well. Otherwise just size the hilborn nozzle and test enderle close in orifice size. Area is the key the lead in and out are just trimming for an iffy hole. I will have a look and if I find out more will let you know.

Alan